View RSS Feed


Running on TEC3

Rate this Entry
Finished up the wiring and got engine to start. Only real set back was the bad crank sensor. That was a easy swap out. Engine fired right up on first try with new sensor just cant get it below 2500. Gotta get that IAC block off installed. Im not going to try to drive it until I understand the new software better and get the idle down. Im just happy everything works for now.

Updated 11-10-2010 at 11:04 PM by importsdontlikeme

Tags: None Add / Edit Tags
Member Builds


  1. phat95nosdsc2's Avatar
    wintec 4 or 3?
  2. importsdontlikeme's Avatar
    Wintec 4, I cannot believe how well the car is running with just the tuning wizard and a few changes to the starting enrichmints.