View Profile: rubensw2 - sixthsphere.com - Saturn Enthusiasts Forum and Community

Today, 05:01 PM

S.Bretz replied to a thread Quick Question (AUDIO) in What's Going On?

I think the stock unit in my 95 was 22w per channel, peak. It wasn't much but it didn't need to be since the stock speakers were cheap paper cones.

1 replies | 32 view(s)

Today, 04:59 PM

S.Bretz replied to a thread 3 Gen SC2 Sail Panel ? in What's Going On?

The sail panel is the inside trim panel by the left and right sides of the back window (or c-pillar moldings).

2 replies | 22 view(s)

Yesterday, 12:24 PM

S.Bretz replied to a thread 3rd Semi annual BBQ feeler in What's Going On?

I wish I could. I have an 18 month old anchor that will prevent me from leaving though. So I hope you guys have a good time. And have a beer for me.

30 replies | 793 view(s)

Yesterday, 12:22 PM

S.Bretz replied to a thread New here, 93 SW2 in n00b Section/Welcome Center

Welcome aboard. What plans do you have for it? Pictures are always a plus. Especially if you start a build thread. This site does have it's...

2 replies | 40 view(s)

09-22-2018, 01:04 PM

S.Bretz replied to a thread Hello Sixthsphere! in n00b Section/Welcome Center

Welcome aboard. Glad we could help broaden your technical knowledge.

7 replies | 916 view(s)

09-22-2018, 01:03 PM

S.Bretz replied to a thread New here but not new. in n00b Section/Welcome Center

Welcome.

3 replies | 54 view(s)

09-20-2018, 08:47 AM

SC2Sick replied to a thread Forced Induction Preparing for Turbo (Advice?) in Turbo / Supercharger

Yeah, I just checked and it's 5 days + 5 posts. Then a utility runs a few times daily to "promote" users to full access. It tends to ward off the...

9 replies | 158 view(s)

09-19-2018, 10:23 AM

S.Bretz replied to a thread Sluggish Caliper? in Suspension & Braking

I have a place by me that i go to. I bring the fittings to them and left them know how much hose i need inbetween and the make them up within a day.

10 replies | 365 view(s)

09-19-2018, 10:20 AM

S.Bretz replied to a thread General Calibration Questions in Tuning / Fuel Management

The stock ecu grounds the injectors too...its easuer to just cut the wires going into the pcm and route them to the ms.

17 replies | 457 view(s)

09-19-2018, 08:37 AM

SC2Sick replied to a thread Forced Induction Preparing for Turbo (Advice?) in Turbo / Supercharger

I think it's 3 posts plus 7 days active then it unlocks FS section? It's not particularly restrictive anymore

9 replies | 158 view(s)

09-19-2018, 08:36 AM

SC2Sick replied to a thread General Calibration Questions in Tuning / Fuel Management

When I did mine I made whole new runs by cutting a bunch of pigtails out of the junkyard for injectors. I left the factory ones ziptied to the back...

17 replies | 457 view(s)

09-19-2018, 08:27 AM

S.Bretz replied to a thread General Calibration Questions in Tuning / Fuel Management

Did you run new injector circuits? Cutting the oem ones and sending them to the ms works just fine...but i have a feeling that is not an option any...

17 replies | 457 view(s)

09-19-2018, 08:25 AM

S.Bretz replied to a thread Forced Induction Preparing for Turbo (Advice?) in Turbo / Supercharger

A straight to4e may be a bit large. You will not start seeing any significant boost until about 4k rpm. A t3/to4e would be good though.

9 replies | 158 view(s)

09-18-2018, 09:02 AM

SC2Sick replied to a thread What did you do to your car today? in What's Going On?

Car looks good. I kind of regret selling my 3G but I needed the driveway space back.

4486 replies | 411638 view(s)

09-18-2018, 08:11 AM

S.Bretz replied to a thread Sluggish Caliper? in Suspension & Braking

I have never seen a soft hose go bad but it can happen if the inner core becomes detatched from the rest of the hose. Maybe get some braided lines...

10 replies | 365 view(s)

09-18-2018, 08:08 AM

S.Bretz replied to a thread Shaking steering wheel. in Technical

Shaking in the steering wheel only when braking is from warped front rotors. You can pick up new white box rotors for about $20 each from a parts...

5 replies | 216 view(s)

09-18-2018, 07:26 AM

S.Bretz replied to a thread General Calibration Questions in Tuning / Fuel Management

You sure it it not a coil? One bad coil will take out two cylinders. I had a bad ICM that would not fire one coil. If you are using OBD1 you need a...

17 replies | 457 view(s)

09-12-2018, 12:17 PM

rubensw2 replied to a thread What did you do to your car today? in What's Going On?

Saturn Bandit! Found on a lemons rally facebook post. Sent from my SM-G950U using Tapatalk

4486 replies | 411638 view(s)

09-11-2018, 01:49 PM

rubensw2 replied to a thread What did you do to your car today? in What's Going On?

Had the mazda5 towed as the transmission no longer wants to accept a gear. Reverse has become a forward gear o.0 not sure if the pressure plate was...

4486 replies | 411638 view(s)

09-07-2018, 06:35 PM

S.Bretz replied to a thread 01' SC2, power loss on open loop, hard bucking at light throttle. in Technical

The coil pack tower ends need to be clean. If you had one corroding and are still using those wires then replace the wires too. Double check the...

4 replies | 182 view(s)

09-07-2018, 06:24 PM

S.Bretz replied to a thread What did you do to your car today? in What's Going On?

The honda transmissions did have an issue with the converters making a surging feeling at low RPM in high gear...but it was at around 1000-1200 RPM...

4486 replies | 411638 view(s)

09-07-2018, 03:24 PM

rubensw2 replied to a thread What did you do to your car today? in What's Going On?

My mazda5's transmission is currently disintegrating before my very eyes. It's trying to pop out of 2nd and making significant noise upon clutch...

4486 replies | 411638 view(s)

09-07-2018, 09:41 AM

S.Bretz replied to a thread What did you do to your car today? in What's Going On?

What trans is in the vue?

4486 replies | 411638 view(s)