View Profile: Saturnguy - sixthsphere.com - Saturn Enthusiasts Forum and Community

Tab Content: All; Saturnguy; Friends; Photos

Older Activity
02-20-2019, 06:40 PM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

How is the luv project going? Do you have a build thread?

see more

33 replies | 2504 view(s)
02-20-2019, 03:32 PM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

Ya the motor is all bolted in I still need a megasquirt 3 and wiring harness, spec clutch and flywheel, flex sensor, fuel pump, fuel filter,...

see more

33 replies | 2504 view(s)
02-20-2019, 03:14 PM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

Im sure the tires will rub a little at full lock but other than that it will be fine

see more

33 replies | 2504 view(s)
02-20-2019, 03:13 PM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

Thanks I've been planning this for a long time and it's great to finally see it coming together

see more

33 replies | 2504 view(s)
02-20-2019, 01:09 PM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

The wheels have a offset of +2 that leaves me with approximately 1.75 inch between the wheel and strut the 255 at it's widest point is is 1.175 wider...

see more

33 replies | 2504 view(s)
02-20-2019, 12:19 PM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

My goal is by the end of October but sooner if possible. I have most of the project figured out but still need about 3k in parts to build it the way...

see more

33 replies | 2504 view(s)
02-20-2019, 09:51 AM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

I'm using the factory axle and half shaft on the passenger side and a cavalier axle on the drivers side

see more

33 replies | 2504 view(s)
02-19-2019, 11:33 PM

Saturnguy replied to a thread What would it take to swap a 3800 into a Saturn? in Ecotec and Beyond

XXR550 16X8.25 +2

see more

33 replies | 2504 view(s)

No More Results

Saturnguy

Saturnguy

Mini Statistics

Recent Visitors

Basic Information

About Saturnguy

Statistics

Total Posts

General Information

02-20-2019

03-27-2018

Quick Nav Links

Sixthsphere Guides

About Us

Search

Connect With Us