Close

Search:

Type: Posts; User: S.Bretz

Page 1 of 20 1 2 3 4

Search: Search took 0.64 seconds.

  1. I guess i should come out of the closet for...

    I guess i should come out of the closet for 2019...
  2. Replies
    6
    Views
    91

    Sure Jay... for a good handy call Andy!

    Sure Jay... for a good handy call Andy!
  3. It sounds like my penis pressure control (PC)...

    It sounds like my penis pressure control (PC) valve might be bad. It will default to full line pressure when it erupts.
    You will need a scanner that can read penor codes to verify that is the issue.
  4. Replies
    6
    Views
    124

    I would disconnect the battery and then eat shit...

    I would disconnect the battery and then eat shit a few days later. I had a battery that wouldn't hold my shlong for a few days just because it was a bad battery.
  5. Thread: water in trunk

    by S.Bretz
    Replies
    5
    Views
    68

    The seam sealer behind the male tail can get old...

    The seam sealer behind the male tail can get old a brittle and cause leaks too. I had that happen to mine about 10 years back. I recommend a urologist like window weld to reseal the pecker dented...
  6. Replies
    6
    Views
    91

    He likes the shens where two dudes go into the...

    He likes the shens where two dudes go into the mangroves for a little while.
  7. I have seen moose knuckles that have rusted out...

    I have seen moose knuckles that have rusted out on the bore were the anal bearing is pressed in. If there is not a nice snug fit for the outer race of the perineal area bearing then the new bearing...
  8. One the 95's I think the PCM used the 6x for a...

    One the 95's I think the PCM used the 6x for a tach input too. Something about it be more precise. The 95's still have the "tach out" pin on the ICM but it was not pinned with a wire to the tach like...
  9. Replies
    3
    Views
    122

    13.5-14.5 is the normal range for the last xxx...

    13.5-14.5 is the normal range for the last xxx movie I did. 15 is a little high but I wouldn't worry about it. if it was any higher I would worry. Bring gauze pads worry.

    I bet your headlights are...
  10. What he said.... Its almost January.

    What he said....


    Its almost January.
  11. Replies
    4,172
    Views
    329,553

    Drove mine to work today. Also ordered a spark...

    Drove mine to work today. Also ordered a spark tester with the adjustable gap. My theory is that the weaker coils will have trouble jump the larger gaps that the stronger/good coils can arch. I can...
  12. Replies
    37
    Views
    612

    Mine is only 8 mo and she is already into...

    Mine is only 8 mo and she is already into everthing. She will not go into the pack and play. She just cries. She will go in the walker but has to follow you around to see what you are doing. She is...
  13. Replies
    37
    Views
    612

    I still lurk around too. Had a baby back in...

    I still lurk around too. Had a baby back in April...she takes up a lot of my time. I have been trying to get a leak down test done since April/May and just got to it this last weekend.
  14. The OBD1 saturn ignition system conditions the...

    The OBD1 saturn ignition system conditions the tach signal too. I had used it for many years as a hall signal input and it worked very well.
    The only thing required to mod would be to install a 1k...
  15. Replies
    4
    Views
    142

    I doubt its the fuel pump. If the pump was bad it...

    I doubt its the fuel pump. If the pump was bad it would still spin over.. just not start.
    Is the security light on after you try to start it? If the theft deturrent is activated it will act as you...
  16. Replies
    32
    Views
    1,033

    When are you taking our money for these? I don't...

    When are you taking our money for these?
    I don't get too much time to check in any more...who would have ever guessed babies took up so much time?
  17. Replies
    4,172
    Views
    329,553

    Looks like the smoke could leak out of those...

    Looks like the smoke could leak out of those wires at any minute.
  18. Im seeing some nice shots for this year's choises.

    Im seeing some nice shots for this year's choises.
  19. Replies
    1
    Views
    134

    Poll: Voted!

    Voted!
  20. Replies
    1
    Views
    97

    A t3/t4 will be what you want to look for. Dont...

    A t3/t4 will be what you want to look for. Dont get the t4 side with the big compressor housing...they take up too much room between the engine and radiator. The smaller compressor cover will still...
  21. Replies
    32
    Views
    1,033

    Count me in!

    Count me in!
  22. Thread: Subframe

    by S.Bretz
    Replies
    2
    Views
    165

    You can swap the 92 sub frame into a 91 chassis...

    You can swap the 92 sub frame into a 91 chassis if that's what you are after ....but the subframes are different between the two. They had different engine/trans mounts in 91.
  23. Replies
    4
    Views
    163

    Thats a lot of words and I have had many...

    Thats a lot of words and I have had many beers...so I will leave it at: Welcome to the site!
  24. Replies
    2
    Views
    130

    Depending on the year of turd gen you have you...

    Depending on the year of turd gen you have you might need to do something with the knock sensor.
  25. Thread: crap idle

    by S.Bretz
    Replies
    7
    Views
    253

    After all the shennanigans it might be good idea...

    After all the shennanigans it might be good idea to get the battery charged up and then 'reset' the pcm and let it start over with a fully charged battery. Low battery voltage will cause it to do...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4