Close

Search:

Type: Posts; User: S.Bretz

Page 1 of 20 1 2 3 4

Search: Search took 0.59 seconds.

  1. Replies
    4
    Views
    121

    Purple is the fastest color they made.

    Purple is the fastest color they made.
  2. Replies
    7
    Views
    145

    That is understandable. As far as backups go,...

    That is understandable.

    As far as backups go, when I build my wife's work PC I ran a raid system on it for redundancy in case of a drive failure. She cannot risk losing any of her data, so it...
  3. Replies
    14
    Views
    366

    IS it still running on the stock ECU or have you...

    IS it still running on the stock ECU or have you installed a MS?
  4. Thread: Request ms2 v3

    by S.Bretz
    Replies
    37
    Views
    1,104

    Fluttering is bad...that is a sign of compressor...

    Fluttering is bad...that is a sign of compressor surge. I better BOV should solve that.

    Set your target a/f's in boost to 12.0 and let autotune do its thing. After a few runs it should pull the...
  5. Replies
    5
    Views
    134

    Welcome back.

    Welcome back.
  6. Replies
    7
    Views
    145

    I would think that with the reduced traffic you...

    I would think that with the reduced traffic you could host the site on a low budget threadripper system from your house...unless your internet sucks there.
  7. Replies
    14
    Views
    366

    If those are platinum plugs... take them out and...

    If those are platinum plugs... take them out and put in regular copper core plugs. I bet that is your problem. The "fancy" plugs mess with the compression sensing on the ICM and that messes up the...
  8. Replies
    14
    Views
    366

    Test fuel pressure. Rent a tester for the parts...

    Test fuel pressure. Rent a tester for the parts store if you do not have one.
    Though I do not think that it is. If it is back firing that would say there is enough fuel in there but it is not...
  9. Thread: Request ms2 v3

    by S.Bretz
    Replies
    37
    Views
    1,104

    The VR conditioner will save you having to mess...

    The VR conditioner will save you having to mess around with adjusting the POTs until you get the right setting.

    The 1k ohm resistor is for OBD1 on the adv signal only....not on the crank sensor...
  10. Replies
    14
    Views
    366

    What is the code from the the SES light? That...

    What is the code from the the SES light? That sounds like a good place to start diag.
  11. Thread: Request ms2 v3

    by S.Bretz
    Replies
    37
    Views
    1,104

    Autotune adjusts fuel only.

    Autotune adjusts fuel only.
  12. Welcome. To answer your question...no the wheel...

    Welcome.
    To answer your question...no the wheel and controls are not compatible.
  13. Replies
    11
    Views
    677

    I used to run a larger 13" pusher fan on the...

    I used to run a larger 13" pusher fan on the turbo side of the radiator and then a smaller puller fan. In my setup I could use only one puller but you may be able to get away with two 8" pullers on...
  14. Replies
    11
    Views
    677

    I would try to find something closer to the 20amp...

    I would try to find something closer to the 20amp range if you can.

    I will update later...right now on the can at eork and typing on a cell phone is a pita.

    The re
  15. Replies
    11
    Views
    677

    Looks about right...no room for a fan after...

    Looks about right...no room for a fan after install. You may be able to get a smaller fan on the radiator that is opposite the turbo. Also, a turbo blanket is a good idea to keep radiant heat of the...
  16. Replies
    11
    Views
    677

    All the grounds for the MS sensors need to be...

    All the grounds for the MS sensors need to be grounded back to the MS itself and then run a ground wire or two out to transmission bolt.

    I would not ground both ends of the shielding. You don't...
  17. Replies
    11
    Views
    677

    The shielding portion gets grounded to. You can...

    The shielding portion gets grounded to. You can use any of the ground pin outs on the db37..then are all attached to the same ground plane on the PCM.
  18. They did that in California.

    They did that in California.
  19. Replies
    13
    Views
    922

    You can remove the knock sensor from the engine...

    You can remove the knock sensor from the engine and then wrap wire around the threads and then ground it to the engine. This will keep any noise out of the sensor so the PCM will not pull timing.
    A...
  20. Replies
    3
    Views
    465

    A piece of pipe that fits, or a seal installer...

    A piece of pipe that fits, or a seal installer tool. You can usually rent the tool for the parts store for a reasonable amount.
  21. Replies
    10
    Views
    1,711

    The spring doesn't care what car it is on. All...

    The spring doesn't care what car it is on. All that matters is the diameter of the spring perches, the height of the spring and the spring rate.
  22. Replies
    13
    Views
    922

    -50% is wicked low. It shouldn't be pulling...

    -50% is wicked low. It shouldn't be pulling anything under -25% max. If it is pulling that much fuel to make the o2 sensor happy then i would suspect you have a leaking injector, a spark misfire on a...
  23. HOLY CRAP. OBX going for $400. That is insane....

    HOLY CRAP. OBX going for $400. That is insane. You used to be able to get them for $100.
  24. Thread: no cranking

    by S.Bretz
    Replies
    2
    Views
    326

    It could be the safety switch. If that is...

    It could be the safety switch. If that is installed then the next thing I would suspect would be that the BCM lost its learned value for the ignition switch. You can try to perform the 30min learn...
  25. Replies
    1
    Views
    262

    Bump start low to be safe but high enough to make...

    Bump start low to be safe but high enough to make power. If it is N/A then start at maybe 25-26 degrees around peak torque. Make a couple of pulls and to get an idea of what it is making then add a...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4