Close

Search:

Type: Posts; User: Plastic Fury

Page 1 of 20 1 2 3 4

Search: Search took 2.47 seconds.

  1. Replies
    34
    Views
    2,114

    I'd be down for one, maybe even see if I can get...

    I'd be down for one, maybe even see if I can get a decent shot of the old girl.
  2. Replies
    12
    Views
    2,856

    I know the font as well. :)

    I know the font as well. :)
  3. Replies
    4,380
    Views
    392,006

    Looks good, always looks good with that extra...

    Looks good, always looks good with that extra "radiator" in there. Too bad about having to have a front plate up there, so much cleaner without it.

    What's the 2G 4x4 sitting next to your coupe?
  4. Replies
    19
    Views
    3,779

    The diagram shows you above but yes, with no P/S...

    The diagram shows you above but yes, with no P/S and no A/C, the belt routes over the idler pulley.

    http://sixthsphere.com/storage2/images/qoarnyi9v0t1e2lb5y7.jpg
  5. Replies
    28
    Views
    3,305

    THIS^^^. Speaking from experience as well and...

    THIS^^^. Speaking from experience as well and from slinging a 1G SC1 (DOHC Swapped) short wheelbase coupe down the Dragon, then slinging a 1G wagon down the dragon, with all the same suspension and...
  6. Replies
    4,380
    Views
    392,006

    I agree!

    I agree!
  7. Replies
    4,380
    Views
    392,006

    It has an o-ringed, thumb screw in the bottom of...

    It has an o-ringed, thumb screw in the bottom of it. It's mounted with 2 10mm's, just takes a minute to loosen and lift it out, to drain it.
  8. Replies
    4,380
    Views
    392,006

    Put the wagon back on the road yesterday, after a...

    Put the wagon back on the road yesterday, after a few months of sitting. Gonna start looking for a new trans, it was already tight to shift before I rebuilt it and now it's just difficult to drive....
  9. Replies
    8
    Views
    2,355

    This is so true haha. I kinda forgot about that,...

    This is so true haha. I kinda forgot about that, I got so used to having the combination of all the mounts and how the car acted but then somebody else happens to hop in and they are like WTF??
  10. Replies
    8
    Views
    2,355

    The Original version of that TAM was called the...

    The Original version of that TAM was called the "Earth Shaker" for a reason. The "Ground Pounder" was the second version of it, I have one of those myself and daily drove it for years along with a...
  11. Replies
    4,380
    Views
    392,006

    With a few setbacks, this has taken much longer...

    With a few setbacks, this has taken much longer than it should have but it's about wrapped up now and ready to be re-installed. Just got a couple odds and ends and then it looks like I'll have time...
  12. Replies
    4,380
    Views
    392,006

    I ordered up a Wiseco 82mm, tapered compressor....

    I ordered up a Wiseco 82mm, tapered compressor. Worked beautifully, the pistons went in fine. Just had to tap one a little with a rubber mallet. Would have had it together today but I spent all...
  13. Replies
    4,380
    Views
    392,006

    Sad part is, this was AFTER I bought a Wiseco...

    Sad part is, this was AFTER I bought a Wiseco 82mm tapered compressor, it did great on three cylinders but somehow, I just messed up on the fourth. Ran it up to the shop this morning and picked it up...
  14. Replies
    4,380
    Views
    392,006

    Caught the oil ring when in stalling piston #4,...

    Caught the oil ring when in stalling piston #4, didn't realize it and forced it like a dumbass. Removed the others and the crank and the block goes back to the shop so that #4 can be re-honed. New...
  15. Why not just run the cable down the passenger...

    Why not just run the cable down the passenger side and then through the passenger side firewall, down low? I have had mine ran that way for years, just drill out a hole, used a grommet and there it...
  16. Replies
    5
    Views
    1,232

    It's just a simple bolt in. There is a little...

    It's just a simple bolt in. There is a little cover that hides where the mounts are, the armrest just sits in there and the two screws hold it in place. Simple.
  17. I'm sorry but I think it looks much better with...

    I'm sorry but I think it looks much better with the 2G lights installed, the fit nice and tight. The 3G lights leave a lot of gaps around them and just have always looked "off" to me, when added to a...
  18. Replies
    13
    Views
    2,511

    I just drilled out my stockers, since I am...

    I just drilled out my stockers, since I am rebuilding the engine anyway, figure every little bit helps. On the Hypers, they have very large drain back openings, what the OEM's should have had.
  19. Will your spare tire cover clear the battery with...

    Will your spare tire cover clear the battery with it standing up, in the bracket? I have an Optima red top, strapped on it's side, in about the same location you have mocked up. I was always...
  20. Replies
    4,380
    Views
    392,006

    Truth! I painted the engine block/cylinder...

    Truth!


    I painted the engine block/cylinder head/TCC today, finally can start putting this thang back together on Monday.
  21. I will pass on what I did and can snap a pic or...

    I will pass on what I did and can snap a pic or two for you tomorrow, if you are interested. The engine is out of the car so it's easy to see right now.

    For the rear ground, if you look toward the...
  22. Ahh okay, I must have been mistaken. I have a...

    Ahh okay, I must have been mistaken. I have a friend that does a lot of 3D printing, if I could find, i'd just give it to him to mock it up so he could make more.
  23. Sure, I suppose. I thought somebody had already...

    Sure, I suppose. I thought somebody had already done it up in a 3D model?
  24. 2nd gen dash, gauge a/c vent panel question

    I thought I read here at one time, that somebody had a 3D print file to make one of these, for the 2G a/c vents? Does anybody know where that is or who might have it?

    Or, does anybody have one of...
  25. Cool way to do it, pretty smart. I relocated...

    Cool way to do it, pretty smart.

    I relocated the battery on the coupe many, many years ago and then just set it up that way in the wagon, since I had all the stuff. I just prefer the battery in...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4