Close

User Tag List

Page 2 of 2 FirstFirst 12
Results 21 to 23 of 23
  1. #21
    trottida's Avatar
    Join Date
    Aug 2014
    Location
    Northern Ontario, Canada
    Posts
    207
    Post Thanks / Like
    Mentioned
    2 Post(s)
    Tagged
    0 Thread(s)
    Here's some information summarized from another thread that should be recorded here ....

    The Thule 400 and 800 series foot packs are compatible with the S Series and require an Thule LB50 load bar (or longer if required) and the appropriate Thule fit kit as per the guide below. All of these have been discontinued by Thule but can be found NOS or used.

    Kit 157 - Gen1 Sedan and Wagon
    Kit 2018 - Gen2/3 Coupe
    Kit 2060 - Gen2/3 Sedan (Note: can be used on a Gen2/3 coupe too, it has 1 additional part that is not needed)
    Kit 265 - Gen2/3 Wagon

    For the GEN2/3 coupe and sedan the mount is permanently installed and requires you to remove the roof trim above the door for installation. Refer to the photo in POST 10 for the finished look with rack installed and not installed.

    The links above will take you to the installation instructions from the http://pauloang.com/thule_fit_kits/ website.

    I imagine if one preferred Yakima racks (like myself) you could use the permanently mounted Thule anchors and the appropriate Q clip used for similar Yakima permanent mounts (truck caps, trailers, ect..) to get the best of both systems.
    Last edited by trottida; 02-07-2018 at 09:47 AM.
    Current
    1999 SL2 MT (272K km, 10-2016 to present)
    2001 SL1 MT (428K km, 10-2008 to present)

    Past
    1993 SW2 AT (03-2000 to 04-2010)
    2001 LW200 MT (06-2001 to 01-2005)
    1992 SL2 MT (06-1992 to 09-1997)

  2. #22
    Get off my lawn.
    Join Date
    Oct 2006
    Location
    Winston Salem, NC
    Posts
    8,392
    Post Thanks / Like
    Mentioned
    20 Post(s)
    Tagged
    0 Thread(s)
    FWIW, I am selling one of the Thule perma-mount setups here: https://sixthsphere.com/showthread.p...3G-sedan-coupe

    I also have a set of pads/clamps for the 1G cars, so if whoever buys is only is willing to separate those out I could pass them on to someone as well.


  3. Likes ZombieSatty liked this post
  4. #23

    Join Date
    Mar 2018
    Posts
    2
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Just purchased the Thule 2060 kit via eBay as I already have the towers and LB50 bar. Though my "NIB" kit did not include the "tensioning attachment" that goes in between the drip rail and left on the car. Would anyone know what this is called or if it was actually supposed to come with my kit?

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •